Dimplex Silverton SVT20 Instrukcje Operacyjne

The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2

9Log Grate Assembly

Caution: Ensure that the logs are placed so that they are not blocking the fl ame effect outlet10Log Grate Assembly

Only use fi ltered tap water in this appliance.Once installed, never move this appliance or lay it on its back, without draining the water from the sum

OperationThe manual controls for the Log Grate are located on the right side (Figure 3).A. On /Standby Switch.Supplies power to the Log GrateB. Moment

Note: Once the mist has been activated, the unit will have to be turned Off, using either the momentary button, on the unit, on the Off button or the

on a biweekly basis. A small brush has been included to assist in cleaning diffi cult items/areas i.e. the transducerCaution: Do not put plastic compon

Symptom Cause Corrective ActionThe fl ame effect will not start.Mains plug is not plugged in.Low water level. Low voltage connector not connected prope

Table of ContentsWelcome and Congratulations ... 2Important Instructions ...

OPTIMYST is a trade mark of GDC Group Ltd.GDC Group Ltd.MILLBROOK HOUSEGRANGE DRIVEHEDGE ENDSOUTHAMPTONSO30 2DFTEL: 0844 879 3589FAX: 0844 879 3583WEB

Welcome and CongratulationsThank you and congratulations for choosing to purchase a Silverton from Dimplex.Please carefully read and save these instru

Important InstructionsPlease read this information guide carefully to be able to safely install, use and maintain your productWhen using electrical ap

Site Selections and PreparationThis section provides instructions for selecting a location and preparing the site to install the Log Grate1. Select a

4. Unpack the transducer (contained within the water reservoir) which has been wrapped to protect it during shipping. See Figure 1.To access the trans

Log Grate AssemblyCaution: Handle logs carefully, they are fragile and can easily crack or break, if dropped.6

Each log is a separate component that needs to be placed on the grate. Position each log so that the hook and loop pad on the backside of the log line

8Log Grate Assembly